Frequency Response
50 Hz-16 KHz,+/-3 dB
THD and SNR
THD: ≤0.7% (1KHz)
SNR: ≥85 dB
Audio Input
1.Input 1-3:-50dBx(MIC)/-10dB x(LINE)
2. 600ΩBGM 1-2:10dBx10KΩ
Audio Output
The total output power applied on CH1-6 no more than 360W, The MAX Mono output power =180W .
Remote Control Port
Connected to the DS-QAE0MP0G1/EN remote microphone.
The distance between the unit and remote microphone can reach 100 meters, Recommened to use (CAT5E-FTP).
Backup Connection
Connected to DS-QAE0A360G1-V6/ENB backup amplifier, Recommended to use CAT5E-STP.
Extension Port
Total 6 ports which can be used to connect with the device DS-QAE0A360G1-V6/ENEX / DS-QAE0A150G1-V/
EN/300G1-V/EN/450G1-V/EN.
Emergency Control Input
2 way input, Available to connect with the fire center and process message control.
General Emergency Control
Input 1-6: No-voltage contact input, short-circuit current below 2mA
Output 1-6: operation current: 10mA below.
External Volume Intrusion Control
6 ways of DC outputs, The voltage used to connect with the device which can be forcibly switched
BGM1/2
2 sets of lotus connectors, External audio source analog signal input.
Common Control Input
6 groups of terminal ports; Switching quantity signal input; None-voltage contace input; Short-circuit current below 2mA.
Common Control Output
6 groups of terminal ports; Switching quantity signal output (relay isolation);
Operating current less than 10mA.
Remote Control Device Port
2 RJ45 ports used to connect with remote emergency microphone (DS-QAE0MP0G1/EN).
Backup Output
1 RJ45 port used to connect with DS-QAE0A360G1-V6/ENB backup amplifier.Recommended to use (CAT5E-STP)
Backup Power Status Input
1 RJ45 port used to the switching-quantity signal based on backup power status.
Voice Message
1 Type-B port used to connect with PC to place the voice files, only support MP3 format.
Monitor
2 lotus connector used to output all audio analog signal from the host.
Zone Expansion
6 ways of RJ45 ports. Connected to the multiple-zone expansion: DS-QAE0A360G1-V6/ENEX/
Single-zone expansion AMP: DS-QAE0A150G1-V/EN/300G1-V/EN/450G1-V/EN
LT Port
LT1 and LT2 used to connect/communicate with signal collector (DS-QASIGNAL/EN).
LT3 used to connect with fire controller.
Network Control Port
RJ45, 1000M bandwith. Used to connect with PC software to upgrade firmware or control system
configuration.
HK - EN
