Global

Global - English

Asia

Europe

Oceania

ANZ - English

Latin America

North America

Middle East and Africa

DS-3E1318P-EI

16 Port Fast Ethernet Smart POE Switch

16 × 100 Mbps PoE RJ45 ports, 2 × gigabit combos.
IEEE 802.3at/af standard for PoE ports.
Network topology management, alarm push, network health monitor.
6 KV surge protection for PoE ports.
AF/AT camera can reach up to 300 m in extend mode.

View Less

Available models:

DS-3E1318P-EI

General
CarcasaMetal material
Peso neto2.59 kg (5.71 lb)
Peso bruto3.68 kg (8.11 lb)
Dimensiones (W x H x D)440.00 mm × 44.00 mm × 220.80 mm (17.32'' × 1.73'' × 8.69'')
Temperatura de funcionamiento0 °C to 45 °C (0 °F to 113 °F)
Temperatura de almacenamiento-40 °C to 85 °C (-40 °F to 185 °F)
Condiciones de humedad5% to 95% (no condensation)
Humedad relativa5% to 95% (no condensation)
Fuente de alimentación 100-240 VAC, 50/60 Hz, Max. 2.5 A
Modo de instalaciónRack (equipped with mounting ears)
Max. El consumo de energía250 W
Consumo de energía en inactivo10 W
Surge Protection6 KV

Parámetros de red
Puertos16 × 10/100 Mbps PoE port,2 × Gigabit combo
Tabla de direcciones MAC16 K
Capacidad de conmutación9.2 Gbps
Tasa de reenvío de paquetes6.84 Mpps
Caché interna4 Mbits

Fuente de alimentación PoE
PoE StandardIEEE 802.3af,IEEE 802.3at
Pin de alimentación PoE8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-)
Puerto PoEPoE: Ports 1 to 16
Max. Puerto de alimentación30 W
PoE Power Budget230 W

Función de software
Largo alcancePorts 1 to 16: up to 300 m. Long range performance may vary depend on camera model or cable condition.
VIP PortPorts 1 to 8: data on VIP ports is preferentially forwarded when bandwidth resources are insufficient.
Port Isolation/
PoE Watchdog/
Link AggregationLink aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection. Support static link aggregation. Support 1 aggregation groups.
QoS/
Loop Prevention/
VLAN/
HPPSupport one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.
System MaintenanceSupport device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Supports 802.1ab LLDP for peer device discovery. Support SNMP v1/v2c for third-party management platform access. Support port mirroring for fault locating.
Port Rate-Limiting/
Storm Control/
IGMP Snooping/
DHCP Snooping/
ACL/
IPSG/

Certificaciones
EMCFCC (47 CFR Part 15, Subpart B),CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020),IC (ICES-003: Issue 7:2020),RCM (AS/NZS CISPR 32: 2015)
SeguridadUL (UL 60950-1),CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017)
QuímicaCE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)

Especificación

General

Carcasa

Metal material

Peso neto

2.59 kg (5.71 lb)

Peso bruto

3.68 kg (8.11 lb)

Dimensiones (W x H x D)

440.00 mm × 44.00 mm × 220.80 mm (17.32'' × 1.73'' × 8.69'')

Temperatura de funcionamiento

0 °C to 45 °C (0 °F to 113 °F)

Temperatura de almacenamiento

-40 °C to 85 °C (-40 °F to 185 °F)

Condiciones de humedad

5% to 95% (no condensation)

Humedad relativa

5% to 95% (no condensation)

Fuente de alimentación

100-240 VAC, 50/60 Hz, Max. 2.5 A

Modo de instalación

Rack (equipped with mounting ears)

Max. El consumo de energía

250 W

Consumo de energía en inactivo

10 W

Surge Protection

6 KV

Parámetros de red

Puertos

16 × 10/100 Mbps PoE port,2 × Gigabit combo

Tabla de direcciones MAC

16 K

Capacidad de conmutación

9.2 Gbps

Tasa de reenvío de paquetes

6.84 Mpps

Caché interna

4 Mbits

Fuente de alimentación PoE

PoE Standard

IEEE 802.3af,IEEE 802.3at

Pin de alimentación PoE

8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-)

Puerto PoE

PoE: Ports 1 to 16

Max. Puerto de alimentación

30 W

PoE Power Budget

230 W

Función de software

Largo alcance

Ports 1 to 16: up to 300 m. Long range performance may vary depend on camera model or cable condition.

VIP Port

Ports 1 to 8: data on VIP ports is preferentially forwarded when bandwidth resources are insufficient.

Port Isolation

PoE Watchdog

Link Aggregation

Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection. Support static link aggregation. Support 1 aggregation groups.

QoS

Loop Prevention

VLAN

HPP

Support one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.

System Maintenance

Support device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Supports 802.1ab LLDP for peer device discovery. Support SNMP v1/v2c for third-party management platform access. Support port mirroring for fault locating.

Port Rate-Limiting

Storm Control

IGMP Snooping

DHCP Snooping

ACL

IPSG

Certificaciones

EMC

FCC (47 CFR Part 15, Subpart B),CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020),IC (ICES-003: Issue 7:2020),RCM (AS/NZS CISPR 32: 2015)

Seguridad

UL (UL 60950-1),CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017)

Química

CE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)

General

CarcasaMetal material
Peso neto2.59 kg (5.71 lb)
Peso bruto3.68 kg (8.11 lb)
Dimensiones (W x H x D)440.00 mm × 44.00 mm × 220.80 mm (17.32'' × 1.73'' × 8.69'')
Temperatura de funcionamiento0 °C to 45 °C (0 °F to 113 °F)
Temperatura de almacenamiento-40 °C to 85 °C (-40 °F to 185 °F)
Condiciones de humedad5% to 95% (no condensation)
Humedad relativa5% to 95% (no condensation)
Fuente de alimentación 100-240 VAC, 50/60 Hz, Max. 2.5 A
Modo de instalaciónRack (equipped with mounting ears)
Max. El consumo de energía250 W
Consumo de energía en inactivo10 W
Surge Protection6 KV

Parámetros de red

Puertos16 × 10/100 Mbps PoE port,2 × Gigabit combo
Tabla de direcciones MAC16 K
Capacidad de conmutación9.2 Gbps
Tasa de reenvío de paquetes6.84 Mpps
Caché interna4 Mbits

Fuente de alimentación PoE

PoE StandardIEEE 802.3af,IEEE 802.3at
Pin de alimentación PoE8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-)
Puerto PoEPoE: Ports 1 to 16
Max. Puerto de alimentación30 W
PoE Power Budget230 W

Función de software

Largo alcancePorts 1 to 16: up to 300 m. Long range performance may vary depend on camera model or cable condition.
VIP PortPorts 1 to 8: data on VIP ports is preferentially forwarded when bandwidth resources are insufficient.
Port Isolation/
PoE Watchdog/
Link AggregationLink aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection. Support static link aggregation. Support 1 aggregation groups.
QoS/
Loop Prevention/
VLAN/
HPPSupport one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.
System MaintenanceSupport device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Supports 802.1ab LLDP for peer device discovery. Support SNMP v1/v2c for third-party management platform access. Support port mirroring for fault locating.
Port Rate-Limiting/
Storm Control/
IGMP Snooping/
DHCP Snooping/
ACL/
IPSG/

Certificaciones

EMCFCC (47 CFR Part 15, Subpart B),CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020),IC (ICES-003: Issue 7:2020),RCM (AS/NZS CISPR 32: 2015)
SeguridadUL (UL 60950-1),CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017)
QuímicaCE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)